ST3250823AS with firmware 3.03 mit Fehlern??

Hallo,

meine Festplatte ist die Seagate ST3250823AS with firmware 3.03.

Unter Speedfan 4.32 zeigt die Festplatte folgendes an:

Almost every EIDE or SATA hard disk includes S.M.A.R.T. data. That information is collected by the drive itself and contains data that the manufacturer considered relevant to check reliability. The data is made up of several attributes that have a current value, a worst one, a threshold, some raw data, and some flags. Basically, when any attribute's current value is below its threshold, the hard disk is considered unreliable and likely to fail. By using several techniques, this report tries to give a wider range of info, basing its analysis on advanced comparisons with normal values based on real hard disks and on expert-like checks. The final results are not to be taken as an absolute truth, but they are a very good approach to what a professional would say about your hard disk status.
Your hard disk is a ST3250823AS with firmware 3.03.
The average temperature for this hard disk is 37C (MIN=27C MAX=48C) and yours is 36C.
Your hard disk's S.M.A.R.T. attributes are now being analyzed and a full report about the reliability, health and status of your hard disk is generated:
Your hard disk is not below any attribute threshold. This is good.
Your hard disk was never below any attribute threshold. This is good.
Your hard disk is now being compared to real data used to define normal values for your specific hard disk model. This way, the analysis can automatically use proper operating ranges. The images give you an idea of how each attribute is within such range. Current and raw values are shown for easier reference for experienced users. There are 1603 hard disk models in the current archive.
Attribute Current Raw Overall

Raw Read Error Rate 54 182123657 Good

Spin Up Time 98 0 Normal

Start/Stop Count 99 1901 Watch
Warning: Start/Stop Count is below the average limits (100-100).

Reallocated Sector Count 100 0 Very good

Seek Error Rate 81 161006361 Very good

Power On Hours Count 97 3423 Good

Spin Retry Count 100 0 Very good

Power Cycle Count 99 1886 Watch
Warning: Power Cycle Count is below the average limits (100-100).

Hardware ECC Recovered 54 182123657 Good

Current Pending Sector 100 0 Very good

Offline Uncorrectable Sector Count 100 0 Very good

Ultra DMA CRC Error Rate 200 1 Very good

Write Error Rate 100 0 Very good

TA Increase Count 100 0 Very good

NOTE: not all warnings are reflected on fitness and performance overall values as relevancy is based upon the settings from the hard disk manufacturer who is the best entity deputed to define such relationships.

NOTE : your hard disk Power Cycle Count attribute current value (99) is below the normal range (100 - 100) reported for your specific hard disk model. Basically your hard disk was power cycled more times than the maximum number the average hard disk was. Power cycles put some stress on the hard disk mechanic. Sometimes power cycles can be caused by a loose hard disk power connector. Make sure it is properly fastened.

The overall fitness for this drive is 97%.
The overall performance for this drive is 97%.
The link to get back and see a new report about this hard disk in the future is this. Consider that new hard disks and new checks are added over time.
DISCLAIMER: this report does its best to highlight issues and warnings related to your hard disk. It cannot be held responsible for any mistake. This page and its results cannot be used in any other way but the one defined by its author.


Das mit dem Warning hat mich erschrecken lassen.

Nun kann ich kein Englisch und kann mit den Daten auch nicht viel anfangen, Weis von Euch da jemand was genaueres?

Ich hänge die Daten auch nochmal als PDF Datei an!

amansi68

 

Da die Platte neu ist, reichen die Werte der Start/Stop-Zyklen und Power Cycle Count vermutlich nicht, um eine klare Aussage zu treffen. Das ist dann mehr ein "in die Kristallkugel schaun".

 

Hallo derupsi,

die Festplatte ist schon fast zwei Jahre alt und läuft (seit 16.11.2005 ) in meinem MD8800 von Medion Aldi.

amansi68

 

Hmmm... ich brauch ne Brille. Ich meinte "meine neue Platte" gelesen zu haben... dabei steht ja bei "Power On Hours Count" 3423 Stunden.
Trotzdem ist da nichts Besorgnis erregendes zu finden.

 

Hallo derupsi,

danke für deine Antwort dann kann ich wieder beruhigt schlafen.